1. Features:
Built-in high performance image processing chip
H.264/H.265 encoding, high compression ratio
1 front 1080P camera
1 rear 1080P camera
Unique GPS drift suppression algorithm
2, Power supply:
Professional vehicle power supply design, 9 - 32V DC wide voltage range
Multiple protection circuits for undervoltage, short circuit, reverse connection, etc.
Intelligent power management system, low voltage shutdown, standby low power consumption
3、Data storage:
Special file management system encrypts and protects data
Proprietary technology detects bad channels on TF card to ensure video continuity and long life of TF card.
Built-in super capacitor to avoid data loss and TF card damage due to sudden power failure.
Supports TF card storage up to 512G.
4、Wireless Module:
Built-in 4G module, support 4G full network pass
Support GPS / Beidou / GLONASS, high sensitivity, fast positioning
WIFI module (optional), frequency 2.4GHz
Built-in 4G, GNSS, WIFI antenna”
HC153 Intelligent Car Recorder
description
- Product Introduction
- frequently asked questions
- precautions
1、Operating System: Embedded Linux Operating System
2、Operating Language: Chinese / English
3、Operator Interface: Configuration via Maintenance Tool
4、Password security: User password management
5、Video Compression: H.265/H.264
6、Image Resolution: 1080P/720P/960H/D1/CIF
7、Recording Quality: 1 – 6 levels selectable
8、Audio compression: G.711A, G.711U, G.726
9、Recording method: synchronized audio and video recording
10、Video Method: Auto/Alarm
11、Audio bit rate: 8Kb/s
12、Video search: Searchable by channel, recording type
13、Upgrade Mode: Manual / Automatic / Remote
14、Upgrade Method: USB flash disk, TF card, wireless network
15、Ignition Input: 1 x ACC signal
16、Audio Input: Built-in microphone
17、Audio Output: Built-in 2W speaker
18、TF card: 1 x TF card port
19、SIM Port: 1x MICRO SIM Port
20、USB Port: 1 x MICRO USB Port
21、LED Indicator: PWR/RUN bi-color light
22、Global Navigation Satellite System (GNSS): Built-in ceramic antenna, GPS + BeiDou + GLONASS
23、Wireless: 4G support
24、WIFI: Frequency 2.4GHz
25、Power input: DC: 8V – 36V
26、Typical power consumption: less than 5W
27、Operating Temperature: – 20 – 70°C
28、Storage: 1080P 600MB/hour/channel H.265; 1080P 1200MB/hour/channel: H.264
29、Size: 125.6 * 86.6 * 46.9mm”Frequently Asked Questions Fault Description Handling method Poor positioning signal Using the terminal in areas with poor reception, such as underneath a tall building or in a basement, it cannot effectively receive satellite airwaves. Use the terminal in a place with good signal. Unable to turn on the computer Repeated switching on and off, the indicator light does not light up Turn on the terminal after 10 seconds with the switch turned OFF. Unable to connect to the network SIM card is not properly installed Check the SIM card and reinstall it. Dirt on the metal surface of the SIM card Please wipe it with a clean cloth. IM card is damaged or invalid Replace the SIM card with a valid one Contact your service provider Out of GSM service area Move to the service area of your network service provider Weak signal Please move to a place with strong signal and try again Can't find the location information GPRS service is not enabled on the SIM card Please contact your network service provider Enable GPRS service SIM card is in arrears Recharge fee Send command to modify the parameter does not change Wrong command format Please edit the command again and send it again No reply to sent command Please make sure the terminal can connect to the network normally and enable the SMS function of the terminal SIM card. 1. Please pay attention to waterproof for electronic products.
2. Please insert the SIM card before installation and make sure the SIM card is not set with password, otherwise the device can not work normally.
3. The USB port on the terminal device is for factory testing only, not for charging the device, please do not use it for charging or other purposes.
4. The installation location must be above a place that is not covered by electromagnetic wave-absorbing substances (e.g., metal, explosion-proof heat insulation film).
5. Do not expose the device to liquids or operate with wet hands.
6. Do not put the device into fire
7. The device may not work when the temperature is lower than -20℃ or higher than +60℃.
8. When the vehicle is in the underground parking lot, tunnel or garage, it will affect the positioning signal. When the vehicle is in underground parking lot, tunnel or garage, it will affect the positioning signal, and there may be a blind area of communication network signal that causes the device can not monitor; when the vehicle drives out of the above area, the device will automatically return to normal work.
9. Do not repair the device by yourself when it encounters abnormal conditions. The manufacturer is not responsible for any damage caused by connecting non-original accessories or unplugging connections between parts.
10. This product is a safe driving aid, and we are not responsible for any damage caused by malfunction or loss of information.
11. This product has passed the international CE certification, but because of the complexity of the electromagnetic environment in the car, this product may cause electromagnetic interference with the electrical equipment in the car in some models.
12. Do not install or operate this product while the vehicle is in motion.
13. Do not connect the uninterruptible power supply without authorization, as this may cause the vehicle or the product to malfunction, and be sure to consult a professional regarding installation.
14. Do not subject the product to strong shocks or vibrations, which may damage the product and cause it to malfunction or become inoperable.
15. The temperature range for normal functioning of the product is from -20 degrees Celsius to 65 degrees Celsius, beyond which the product may malfunction, catch fire or explode.
You May Also Like
Related Solutions